www.changlin.com.cn 3/8 Inch Loosen the Stanadyne DB4 fuel injection pump lock screw and position the special washer behind the lock screw head. Tighten the lock screw. 10 mm NOTE: On the Bosch pump, the special washer is wired to the pump and must be installed under the lockscrew. Tighten the pump lockscrew. Torque value: 13 N • m [10 ft-lb] NOTE: Be sure to disengage the timing pin. 10 mm Install the injection pump support bracket. Finger tighten all cap screws before final tightening. NOTE: Tighten the bracket to block mounting cap screw before tightening the bracket to injection pump cap screws. 117 / 167 pages