www.changlin.com.cn Fuel Shutoff Solenoid‐Replacement Preparatory Steps: Label and disconnect the wiring. RQVK Governor Shutoff Solenoid 10 mm Remove the hitch pin clip, mounting capscrews and the fuel shutoff solenoid. Install the new solenoid in reverse order of removal and connect the wires. Torque Value: 10 N*m [89 in-lb] 10 mm, 16 mm Adjust the solenoid linkage as necessary so that the plunger is magnetically held in with the shutoff lever in the absolute full run position. Turn the large hex on the end of the plunger to make adjustments. injection Pump‐Replacement Preparatory Steps: Clean debris. Remove all fuel lines. Remove control linkage. Remove fuel shutoff solenoid.
Remove AFC air line Remove oil line(s) 126 / 167 pages