Cummins — HG130, HG170 Engine Manual

www.changlin.com.cn Clean all external surfaces of the injection pump, including all line connections and fittings that are to be disconnected. Clean the area around the injection pump gear cover to prevent dirt from entering the crankcase. Injection Pump-Removal 3377371 Engine Barring Gear Locate TDC for cylinder No. 1. Push the TDC pin into the hole in the camshaft gear while slowly barring the engine. NOTE: Be sure to disengage the pin after locating TDC. 30 mm (P7100 Pump) Remove the gear cover access cap. Remove the nut and washer from the fuel pump shaft. 127 / 167 pages NOTE: A diesel engine can not tolerate dirt or water in the fuel system.

A tiny piece of dirt or a few drops of water in the injection system may stop your units. 10 mm Remove the fuel pump mounting bracket. 0 mm emove the fuel pump mounting bracket.