www.changlin.com.cn Cooling System Flushing Caution: During filling, air must be vented from the engine coolant passages. Open the engine venting pet- cock and the petcock on the aftercooler for aftercooled engines. The system must be filled slowly to prevent air locks. Wait 2 to 3 minutes to allow air to be vented, then add mixture to bring the level to the top. Fill the system with a mixture of sodium carbonate and water (or a commercially available equivalent). NOTE: Use 0.5 kilogram [1.0 pound] of sodium carbonate for every 23 liters [6.0 U.S. gallons] of water. Caution: Do not install the radiator cap. The engine is to be operated without the cap for this process.
Operate the engine for 5minutes with the coolant temperature above 80°C [176°F]. Shut the engine off and drain the cooling system. Fill the cooling system with clean water. NOTE: Be sure to vent the engine and aftercooler for complete filling. NOTE: Do not install the radiator cap or the new coolant filter. 60 / 167 pages