www.changlin.com.cn Operate the engine for 5 minutes with the coolant temperature above 80°C [176°F], Shut the engine off and drain the cooling system. NOTE: If the water being drained is still dirty, the system must be flushed again until the water is clean. Coolant System Filling The system has a maximum fill rate of 14 liters per minute [3.5 U.S. Gallons per minute]. Do not exceed this fill rate. Caution: The system must be filled slowly to prevent air locks. During filling, air must be vented from the engine coolant passages. Be sure to open the petcock on the aftercooler for aftercooled engines.
Wait 2 to 3 minutes to allow air to be vented, then add mixture to bring the level to the top. Use a mixture of 50 percent water and 50 percent ethylene glycol antifreeze to fill the cooling system. *4BTAand 6BTA engines use a jacket-water aftercooler. If a Charge Air Cooler is used, the coolant capacity is the same as the naturally aspirated or turbocharged only engines. Caution: Never use water alone for coolant. Damage from corrosion can be the result of using water alone for coolant. 61 / 167 pages Coolant Capacity (Engine Only) Liter [U.S. Quarts] 4B3.9 6B5.9 4BT3.9 4BTA3.9* 6BT5.9 6BTA5.9* 7.0 [7.4] 7.9 [8.4] 9 [9.5] 9.9 [10.5]