Cummins — HG130, HG170 Engine Manual

www.changlin.com.cn Intall the pressure cap. Operate the engine until it reaches a temperature of 80°C [180°F], and check for coolant leaks. Check the coolant level again to make sure the system is full of coolant, or that the coolant level has risen to the hot level in the recovery bottle on the system, if so equipped. Warning: Before removing the pressure cap, wait until the coolant temperature is below 50 °C [120°F]. Failure to do so can cause personal injury from heated coolant spray. Vibration Damper (Rubber) Inspection Check the index lines (A) on the damper hub (B) and the inertia member (C). If the lines are more than 1.59 mm [1/16 inch] out of alignment, replace the damper.

Inspect the rubber member for deterioration. If pieces of rubber are missing or if the elastic member is more than 3.18 mm (1/8 inch] below the metal surface, replace the damper. NOTE: Also look for forward movement of the damper ring On the hub. Replace the damper if any movement is detected. 62 / 167 pages