Cummins — HG130, HG170 Engine Manual

www.changlin.com.cn Clean the gasket surfaces. NOTE: Do not let any debris fall into the thermostat cavity when cleaning gasket surface. Caution: Always use the correct thermostat and never operate the engine without a thermostat. An incorrect thermostat can cause the engine to overheat or run too cold. The engine will overheat if operated without a thermostat because the coolant flows back to the inlet of the water pump instead of through the radiator for cooling. Assemble the removed parts in the reverse order of removal. Make sure the gasket is aligned with the cap screw holes. Install the cap screws and use your fingers to tighten.

The notched end of the rubber thermostat seal points away from the cylinder head. 10 mm Tighten all Cap screws. Torque Value: 24 N*m [18 ft-lb] 96 / 167 pages