CLAAS LEXION II (480 - 405) — gb 00 Deckblatt

CLAAS ACADEMY LEXION II Additional functions Key to diagram Y78 - Returns valve with pressure relief valve . . . . 60 bar Y83 - Solenoid valve for swinging the Uni-spreader to the left Y84 - Solenoid valve for swinging the Uni-spreader to the right T - Connection to tank P - Connection to the hydraulic pump A - Hydraulic ram port for swinging the Uni-spreader to the right B - Hydraulic ram port for swinging the Uni-spreader to the left V - Valve insert for the lock valve Function – neutral When the threshing system is engaged the relative hydraulic pump for the Uni-spreader is also engaged. The oil flows through the open returns valve (Y78) and back to tank.

Both ends of the hydraulic ram are connected together through the non switched solenoids (Y83/Y84). The Uni-spreader can be operated by hand, and locked in the middle position. Function – swinging When required, one of the solenoid valves are operated (Y83/Y84) and at the same time the lock valve (Y78). The relative spool, presses the ball off its seat and closes the flow back to tank. Oil flows to the hydraulic ram from P. Oil returning from the ram comes in at the non switched solenoid (Y83/Y84) and returns to tank. The lock valve is designed to allow flow when the hydraulic ram meets its end stops. This reduces pressure spikes and also constant pressure within the ram.

Because of the requirement of the valve inserts and the relatively large size of ball in the returns valve (Y78), it is not enough to rely on the electromagnetic force of the solenoid to maintain system pressure. For this reason the ball in the valve unit (Y78) will release oil at 55 +5 bar . Note: Once the cutterbar has been engaged, the module swings the Uni-spreader completely to the right and then completely to the left, this enables the module to learn the end stops. The solenoid valves (Y83/Y84) will then be controlled by the module, with respect to the angle and degree of movement. 11/2001 4-33