CLAAS LEXION II (480 - 405) — gb 00 Deckblatt

CLAAS ACADEMY LEXION II Additional functions Key to diagram 513 - Accumulator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.075 l / 15 bar 736 - Pressure relief valve for Uni-spreader . . . . . .

55 +5 bar Y83 - Solenoid valve for swinging the Uni-spreader to the left Y84 - Solenoid valve for swinging the Uni-spreader to the right T - Connection to tank P - Connection to the hydraulic pump A - Hydraulic ram port for swinging the Uni-spreader to the right B - Hydraulic ram port for swinging the Uni-spreader to the left E - Adjusting screw for pressure relief S - Control spool Function – neutral When the threshing system is engaged the relative hydraulic pump for the Uni-spreader is also engaged. The oil then flows over the ring channel of the control spool (S) and back to tank. Both ends of the hydraulic ram are connected together through the control spool (S).

The Uni-spreader can be operated by hand, and locked in the middle position. Function – swinging When the system is energised, then the solenoid valve (Y83/Y84) is also switched. The control spool (S) then connects the P port to one side of the hydraulic ram, and the other side of the ram is connected to tank. The accelerator (D) stops any pressure peaks from within the system. The spring within the pressure relief valve is set to 55 +5 bar , and can be adjusted on the adjusting screw (E). Note: Once the threshing has been engaged, the module swings the Uni-spreader completely to the right and then completely to the left, this enables the module to learn the end stops.

The solenoid valves (Y83/Y84) will then be controlled by the module, with respect to the angle and degree of movement. 11/2001 4-35