TIC LEXION 480-405 Front attachment Key to diagram 314 - Slave cylinder for reel height adjustment 315 - Master cylinder for reel height adjustment 316 - Hydraulic ram for reel fore and aft adjustment 343 - Hydraulic ram for folding the cutterbar 360(a) - Hydraulic ram for locking into the transport position 360(b) - Hydraulic ram for locking in work position 406 - Orifice plate . . . . . . . . . . . . . . . . . . . . . . . . . . . Ш 0.8 mm 408 - Orifice plate . . . . . . . . . . . . . . . . . . . . . . . . . . .
Ш 1.2 mm 623(a) - One-way valve (pilot operated) 623(b) - One-way valve (pilot operated) 734 - One-way valve (lock-up valve unit) 801 - Quick release coupling (P/T) for front attachment Y22 - Solenoid valve for raising the reel Y23 - Solenoid valve for lowering the reel Y24 - Solenoid valve for reel forward Y25 - Solenoid valve for reel backward Y65 - Solenoid valve for folding the cutterbar to work position Y66 - Solenoid valve for folding the cutterbar to transport position Y69 - Solenoid valve for lock valve T - Connection to tank P1 - Pump connection via the returns valve A1 - Hydraulic ram port for reel height adjustment A2 - Hydraulic ram port for reel fore and aft adjustment, backwards B2 - Hydraulic ram port for reel fore and aft adjustment, forwards A3 - Hydraulic ram port for table adjustment B3 - Hydraulic ram port for table adjustment A4 - Hydraulic ram port for folding the cutterbar to work position B4 - Hydraulic ram port for folding the cutterbar to transport position Folding function For unfolding and folding of the cutterbar, the hydraulic rams (360a/b) are operated first in order to unlock the system.
This is able to be done, as this requires less pressure to operate, than it does to operate the folding hydraulic rams (343). During the folding process is carried out at a later stage with the hydraulic rams (360a/b) that is when pressure is available, but not yet as the piston rod end is blocked by the corresponding one-way valve (623a/b). These one-way valves stay closed until either the folding ram (623a) reaches the end stop or the frame (623b) is completely home, so will only lock in the completely unfolded or folded condition. The one-way valve (Y69) stops the oil flow to the cutterbar when the road travel switch has been locked.
A screw on the one way valve (623b) can adjust the time of regulation into the working position. Note: The circuit diagram shows the position of the hydraulic rams for the locking to the transport position. 03/2004 5-7