CLAAS LEXION II (480 - 405) — gb 00 Deckblatt

TIC LEXION 480-405 Front attachment Key to diagram 406 - Restrictor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Ш 0.8 mm Y22 - Solenoid valve for raising the reel Y23 - Solenoid valve for lowering the reel Y69 - Solenoid valve for lock valve T - Connection to tank P1 - Pump connection via the returns valve A1 - Reel height adjustment hydraulic ram port The hydraulic ram is tightly locked by the ball valve in the valve insert at the connection A. Function – neutral Safety switching The safety valve (Y69) locks the oil flow for several functions on the cutterbar, when there is a fault and the electrical connection to the safety switch is lost.

The safety switch allows the folding procedure to continue, only when the reel is completely down and back and the transport regulator has been slackened off. Function reel raise The solenoid valve (Y22) and the returns valve are switched together. The relative solenoid pushes the ball off its seat and at the same time shuts off the flow to tank. The oil then flows to the second solenoid valve (Y23) where the pressure pushes the ball off its seat and flows out of port A. Function reel lower The solenoid valve (Y23) is switched without the returns valve.

The solenoid pushes the ball off its seat, thus allowing the oil to flow from the port A, over the valve, across the solenoid (Y22) that is not operated and finally back to tank. 03/2004 5-21