CLAAS LEXION II (480 - 405) — gb 00 Deckblatt

CLAAS ACADEMY LEXION II Low pressure hydraulics Key to diagram 104 - Tank vent 107 - Oil drain 110 - Oil tank 112 - Working hydraulics sieve filter 115 - Grease reservoir for grain tank unloading 205 - Gear pump for working hydraulics . . . . . . . . . 14 cmі 208 - Axial piston pump for hydrostatic ground drive 218 - Gear pump for steering hydraulics . . . . . . . . . 11 cmі 231 - Grease pump for grain tank unloading 301 - Hydraulic ram for 3D sieve box . . . . . . . . . . . . Ш 50/10 mm 308 - Hydraulic ram for diesel engine rpm 312 - Hydraulic ram for threshing engagement . . . Ш 50/40 mm 321 - Hydraulic ram for grain tank unloading . . . . .

Ш 40/30 mm 335 - Hydraulic ram for moisture measuring 339 - Hydraulic ram for servo line 347 - Hydraulic ram for chopper engagement 352 - Hydraulic ram for front attachment engagement 412 - Restrictor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Ш 2 mm 426 - Bolt with restrictor hole . . . . . . . . . . . . . . . . . . . Ш 0.8 mm 441 - Rotary coupling 601 - Pendulum valve 3D sieve box 715 - Short-circuit valve for servo line 729 - Pressure relief valve . . . . . . . . . . . . . . . . . . . . . 19 +4 bar 731 - One-way valve 748 - One-way restrictor . . . . . . . . . . . . . . . . . . . . . .

Ш 0.8 mm 910 - Test port Y13 - Solenoid valve for engine speed – 1 st step Y14 - Solenoid valve for engine speed – 2 nd step Y21 - Solenoid valve for threshing engagement Y35 - Solenoid valve for grain tank unloading Y52 - Solenoid valve for moisture measuring Y59 - Solenoid valve for servo line Y76 - Solenoid valve for chopper engagement Y88 - Solenoid valve for front attachment engagement Z46 - Oil pressure switch . . . . . . . . . . . . . . . . . . . . . .

12 bar T - Connection to tank P - Connection to charge pump for ground drive P1 - Connection for 3D sieve box and moisture measuring S - Connection to grease brush for grain tank unloading Function problems A problem in the low pressure system is usually down to the fact that one of the components is leaking oil either internally or externally. In order to find the fault it is necessary to connect a test gauge to the system and then engage each individual service. The one where the pressure is lost is the one at fault. Note: The restrictor (412) is in the system to reduce the oil flow to between 5 and 7 l/min .

This ensures that even with large leakage in the system, the charge pump for the ground drive should not be starved of oil. 11/2001 6-5