CLAAS ACADEMY LEXION II Low pressure hydraulics Key to diagram 301 - Hydraulic ram for 3D sieve box . . . . . . . . . . . . . Ш 50/10 mm 426 - Screw with restrictor hole . . . . . . . . . . . . . . . . . Ш 0.8 mm 601 - Pendulum valve for 3D sieve box T - Connection to tank P - Connection to charge pump for hydrostatic drive A - Hydraulic ram port for 3-D sieve box B - Hydraulic ram port for 3-D sieve box a - Cover b - Pendulum c - Housing d - Control spool e - Bleeding screw (M6 x 16) Function As soon as the machine moves onto a slope, the angle of the pendulum housing (c) and the position of the control spool (d) also changes. The pendulum itself (b) always remains horizontal.
This causes the oil (P) to flow to one side (A/B) of the hydraulic ram(301), with the second side being connected back to tank (T) via the pendulum housing (C). The hydraulic ram (301) moves the pendulum so that the housing is back in the vertical position, and the valve (601) is back in the neutral position. The pendulum housing (c) is connected to the sieve box by a mechanical link. The angle of the slope plays a direct relation on the amount of movement by the pendulum housing. Bleeding the 3D system When filling or bleeding the pendulum housing, firstly slacken off the bleed screw (e) so that the oil can flow out unrestricted.
With the connecting rod disconnected, and the engine on tick over, the pendulum housing (C) can be swung until all the air has been removed. Note: When the system is in operation, the large hole in the screw (426) must be closed, otherwise the housing (C) will be forced against the end stop by the uncontrolled oil flow. 11/2001 6-15