CLAAS LEXION II (480 - 405) — gb 00 Deckblatt

TIC LEXION 480-405 SAUER hydrostatic drive Key to diagram 1 - Oil tank 124 - Oil cooler 144 - Connection for the return flow from the steering 201 - Charge pump . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 cmі 202 - Filter cartridge . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 µm 205 - Charge pump pressure relief valve . . . . . . . . . . . . 30 ± 2.5 bar 206 - Control pressure, pressure relief valve . . . . . . . . . 7 bar 211 - Multifunction valve – reverse 212 - Multifunction valve – forwards 213 - Servo control valve 216 - Servo ram 217 - Axial ram adjustable pump . . . . . . . . . . . . . . . . . . . 100/130 cmі 220 - Fixed displacement motor . . .

. . . . . . . . . . . . . . . . . 100 cmі 221 - Shuttle valve 222 - Purge valve S - Charge pressure circuit H - High-pressure circuit R - Purge return oil Z - Control pressure channel Oil supply Once the engine has been started, then both the steering pump and the charge pump (201) are running. A proportion of the oil quantity on the suction side of the charge pump (201) is fed over the return line of the steering (144) and to the oil cooler (124). The rest of the oil from the charge pump (201) flows out of the purge return through the housing of the adjustable pump (217) and then back to tank (1).

Charge pressure circuit The charge pressure builds up due to the charge pump (201), pumping oil through the filter (202) and against the pressure relief valve (205). Depending on the spring adjustment in the valve (205), the oil will be pressurised and returned to tank. The charge pressure stands at the servo control valve (213) and at the multifunction valves (211/212). When the pump (217) is not swashed, then the charge pressure flows over the valve in the multifunction valves (211/212) on both sides of the high-pressure circuit.

Servo adjustment When the servo valve (213) is operated by the cable from the hydrostatic lever, then it moves out of the neutral position in one direction or the other. Depending on the direction of travel selected, will determine the direction of the servo ram (216), which will create pressure on one side but the opposite side will be open to tank. The servo ram (216) will then adjust the swash plate in the pump (217), but only the amount selected on the hydrostatic lever, and a mechanical response to the angle is delivered to the servo control valve (213).

The mechanical response balances the control spool in the control valve (213) and so the pressure remains on the edge, thus ensuring that the swash angle remains. 03/2004 7-19