CLAAS LEXION II (480 - 405) — gb 00 Deckblatt

TIC LEXION 480-405 SAUER hydrostatic drive Key to diagram 201 - Charge pump . . . . . . . . . . . . . . . . . . . . . . . . . 26 cmі 213 - Servo control valve 216 - Servo ram B - Control floor D - Shaft seal F - Return spring G - Slipper H - High pressure K - Plunger L - Bearing N - Mechanical neutral adjustment R - Cylinder rotor S - Swash plate W - Drive shaft Function (see also page 7-2) As soon as the engine is started, then the cylinder rotor (R) with those nine radials on the drive shaft (W), the plunger (K) and the charge pump (201) are urged on.

The plunger (K) due to the fact that on both sides of the high pressure (H) stands charge pressure, the slippers (G) are pressed onto the swash plate (S). By operating the servo control valve (213) the servo cylinder (216) is moved which moves the swash plate (S) so that the desired direction and speed is selected. Because of the swash movement, the plungers (K) experience an axial loading, which causes the oil to flow in the cylinder area, the pressure then increases to overcome the motors resistance.

As soon as the whole quantity of oil in the cylinder area is displaced, the rotating rotor (R) and plunger (K) are pressed back against the slope of the swash plate (S) on the low-pressure side as a consequence of the charge pressure. The cylinders in the rotor (R) are on the diminishing side filled up one after the other (low pressure) and then turns this oil quantity on the steep side (high pressure) against the motor. Depending on the direction, the swash plate (S) can be swashed in one direction or the other, which means that either side can be high pressure and low pressure. The speed is dependent on the oil quantity and therefore on the amount the swash plate has been swashed.

The hydrostatic lever adjusts the swash angle via the mechanical response on the swash plate (S) on the servo control valve (213). The low-pressure side and the high-pressure side are separated by the control floor (B). To ensure a good seal, the cylinder rotor (R) is pressed against the control floor (B) by a spring. The exact adjustment of the swash plate in the neutral position is done by the pressure springs (F), where the adjustment itself is done by a mechanical neutral eccentric bolt (N). 03/2004 7-23