CLAAS LEXION II (480 - 405) — gb 00 Deckblatt

TIC LEXION 480-405 SAUER hydrostatic drive Key to diagram 221 - Shuttle valve 222 - Purge valve B - Control floor D - Shaft seal G - Slipper K - Plunger L - Bearing R - Cylinder rotor S - Swash plate W - Drive shaft Function (see also page 7-2) As soon as the engine is started, then the charge pump is energised. The plungers (K) in the cylinder rotor (R) of the motor, due to the fact that on both sides of the high-pressure lines is charge pressure, the slippers (G) are pressed against the swash plate (S). As soon as the pump is swashed, then the pressure is built up against the nine plungers (K) in the cylinder rotor (R) which is connected to the drive shaft (W).

The plungers (K) press against the swash plate (S) and the energy is then used to overcome the resistance on the drive shaft (W). The rotation is dependent on the direction of the oil flow which is created by the swash angle of the pump. The high-pressure side and the low-pressure side can be alternated. The speed is governed by the amount of oil and that is dependent on how large an angle has been selected within the pump. The high pressure and the low pressure are separated by the control floor (B). To seal, the cylinder rotor (R) presses against the control floor (B) using springs.

Dependent on the high-pressure side within the high-pressure circuit, the shuttle valve (221) in the motor is switched, so that the respective low-pressure is purged (222) over the connection to the motor housing. Because the pressure setting of the purge valve (222) is smaller than that of the charge pressure, oil constantly flows via a restrictor in the purge valve (222). 03/2004 7-27