TIC LEXION 480-405 SAUER hydrostatic drive Key to diagram B - Cam track K - Roller rams V - Distribution block Z - Cylinder rotor A - Connection to the high-pressure circuit B - Connection to the high-pressure circuit Function The wheel motors are like the radial motors, and should the machine have to be towed, then they do not need to be disconnected mechanically. The force from the wheels acts on the motor and turns the cam track (B), the ten roller rams (K) in the cylinder rotor (Z) so that the wheel hub turns freely. When the 4 wheel drive is energised, then the motor travels in the relative direction dependent on which port A or B has been supplied with oil.
The distribution block (V) urges the roller rams (K) that are in the declining position of the cam track (B). The roller rams (K) thrust themselves against the cam track (B) and pushes the cylinder rotor (Z) in a rotary motion. This motion is transmitted via the splines to the wheel hub. When the roller ram (K) travels over the lip in the cam track (B) the oil flows over the cylinder rotor (Z) to the distribution block (V) to the low- pressure side of the high-pressure circuit. 03/2004 7-31