TIC LEXION 480-405 Standard machine functions The following describes the operation of the individual valve cartridges, this also enables the difference of each valve to be noted. Description of operation 631 444.0 This valve is designed with a spool control valve, whereby the return to tank is closed before the ball ist displaced from its seat. A positive switching is possible when the system is over-pressurised, or when peak pressures are experienced in the tank lines. This valve is used when these facts could effect the operation of the system.
The stroke of the valve is dependent on the stroke of the solenoid, where max force is obtained at the end of the stroke and the switching delay time is dependent on the redidual magnetism of the solenoid. Ball seat 2.5 mm Spool 2.8 mm 631 442.0 This valve operates in much the same way as the 631 444.0. Ball seat 2.0 mm Spool 2.8 mm The smaller ball seat reduces the amount of flow but enables the valve to operate quickly when not much oil flow is delivered. 631 483.0 The pin valve has via the pin a mechanical end stop, which means that the solenoid does not reach its stops. This valve in comparison to the spool control valve switches off very quickly.
In practice there is no hydraulic return time, and the valve is returned by a spring in the solenoid (marked with an “F” on the solenoid). The large pin has the task of being the pressure relief valve. The small ball acts as restrictor and allows the valve to operate against higher pressures when small oil flows are involved. Ball seat 1.8 mm Pin seat 4.1 mm 631 500.0 This valve operates in much the same way as the 631 483.0. Ball seat 2.0 mm Pin seat 2.9 With the smaller pin seat there is no pressure-relief function since the force from the solenoid valve is sufficient for a system pressure of at least 190 bar. 03/2004 3-15