CLAAS LEXION II (480 - 405) — gb 00 Deckblatt

TIC LEXION 480-405 Standard machine functions Key to diagram Neutral function 405 - Orifice plate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Ш 0.6 mm 705 - Pressure relief valve . . . . . . . . . . . . . . . . . . . . .

90 ± 5 bar 732 - One-way valve (not pilot controlled) 734 - One-way valve (lock-up valve unit) 748 - Restrictor Y17 - Solenoid valve for narrowing the threshing concave (close) Y18 - Solenoid valve for widening the threshing concave (open) T - Connection to tank P1 - Pump connection via the returns valve A4 - Hydraulic ram for closing the threshing concave (LHS) B4 - Hydraulic ram for opening the threshing concave (RHS) V - Valve insert K - Plunger Both sides of the hydraulic ram are shut off tightly by the one-way valves (732, 734) in the consumer ports A and B. Threshing concave narrow function (close) The solenoid valve (Y17) and the returns valve are switched.

The relative solenoid opens the valve, which in turn closes the flow back to tank. The pressure then builds up which forces the plunger (K) to open the lock valve (734) at port (B). The return of the oil from the ram then flows via the solenoid (Y18) back to tank. The pressure then opens the lock valve (732) and opens the connection to (A) and the rams then travel out. Threshing concave wide function (open) The solenoid valve (Y18) and the returns valve are switched. The relative solenoid opens the valve, which in turn closes the flow back to tank. The pressure then builds up which forces the plunger (K) but does not open the lock valve (732) at port A.

The return oil from the hydraulic ram is locked by the lock valve (732). The pressure then opens the other lock valve (734) at port B which allows oil to flow out to the ram. The return oil then flows back to tank via the pressure relief valve (705). The system is so designed to enable it to go onto an exact position and would not open on its own accord. Note: Narrowest gap of the concave cannot in practice be achieved by the rams. The reason is that at the ram face is situated a valve that will then open allowing oil to flow through. The purpose of this is to ensure that both rams can be equalised.

In practice the rams can be closed, but must be opened slightly thus closing the bottom valves. 03/2004 3-35