CLAAS LEXION II (480 - 405) — gb 00 Deckblatt

TIC LEXION 480-405 Standard machine functions Key to diagram 226 - Hydraulic motor for reversing the front attachment . . . . . . . . . . . . . . . . . . . . . OMR 200 353 - Hydraulic ram for reversing the front attachment . . . . . . . . . . . . . . . . . . . . . Ш 22 mm 732 - One-way valve Y86 - Solenoid valve for reversing the front attachment A - Solenoid valve port for reversing the front attachment B - Connection to the hydraulic motor Function When the solenoid valve (Y86) is switched, the reversing ram (353) is driven out and pushes the hydraulic motor (226) onto the sprocket.

Just before it reaches its end stop, the oil flow is switched from the ram (353) to the hydraulic motor (226). This is done to ensure that the motor is correctly meshed. The one-way valve (732) stops the motor from turning, should a hydraulic spike appear in the system. Adjustment With the use of an eccentric bush, the adjustment of the reversing ram (353) can be adjusted to the drive shaft of the intake housing. The adjusting bolt in the ram should be so adjusted that the hydraulic motor (226) has maximum engagement, with approx. 0.2 mm axle play on the drive sprocket.

The screw should be adjusted so that it has 0.5 mm gap to the end stop, when the reverser is engaged, and should be locked in this position. The complete movement of the reversing ram (353) is 12 mm, whereby after 11 mm oil is fed through to the hydraulic motor. Components of the reversing motor OMP 200 03/2004 3-47