CLAAS LEXION II (480 - 405) — gb 00 Deckblatt

CLAAS ACADEMY LEXION II Additional functions Key to diagram 305 - Hydraulic ram for cross-levelling (right-hand side) . . . . . . . . . . . . . . . . . . . . . . . . . Ш 70 / 50 mm 306 - Hydraulic ram for cross-levelling (left-hand side) . . . . . . . . . . . . . . . . . . . . . . . . . Ш 70 / 50 mm 502 - Cross-levelling accumulator . . . . . . . . . . . . . . .

0.7 l / 80 bar 602 - Tap 603 - Pressure relief screw 732 - One-way valve (delivery valve) 734 - Lock valve (lock-up valve unit) 740 - Flow control valve Y67 - Solenoid valve for cutterbar cross-levelling (left-hand side) Y68 - Solenoid valve for cutterbar cross-levelling (right-hand side) A - Cross-levelling solenoid valve port B - Hydraulic ram port (right-/left-hand side) E - Bleed screw F - Piston guide Caution: When dismantling 732, 502,740, Y67 or Y68, the pressure must be released from the accumulator using the pressure relief screw (603). Bleeding the hydraulic rams 1. Remove the front end attachment. 2. Open the tap (602) 3.

Operate the rocker switch towards the right, so that both hydraulic rams (305/306) have fully extended. 4. Slacken off the bleed screw E on both rams. 5. Operate the rocker switch quickly once more, until the oil comes out air free. 6. After all the air has been expelled, retighten the bleed screw E 7. Operate the rocker switch, until the left hand ram (306) is fully retracted. 8. Close off the tap (602) 9. Using the rocker switch, extend and retract both rams (305/306) several times. Lowering both rams (for multimaster) 1. Attach the front end attachment. 2. Operate the rocker switch so that the right hand ram (305) extends fully and the front end attachment tilts anti clockwise. 3.

Open the tap (602) 4. Operate the rocker switch so that the right hand ram (305) fully retracts. 5. Close the tap (602). Levelling both rams (for cutterbars) 1. Remove the front end attachment. 2. Open the tap (602). 3. Operate the rocker switch towards the right, so that both hydraulic rams (305/306) have fully extended. 4. Operate the rocker switch, until the right hand ram (305) is fully retracted. 5. Close the tap (602) 6. Using the rocker switch, level out both hydraulic rams (305/306). 11/2001 4-23