Toyota — Service Manual Change History

19-97 Electrical System Troubleshooting z Error codes 71-1 and 71-2 (Tire angle sensor abnormality) Related portion A21 AO1 ZO1 Z3 Probable cause c Connector contact defect d Tire angle sensor harness defect e Tire angle sensor defect f Tire angle sensor joint, rear axle link system defect g SAS/OPS controller defect Error code 71-1 Connector contact defect Tire angle sensor defect Harness defect SAS/OPS controller defect Harness defect Inspection 1: Carry out tire angle sensor individual inspection.

Ignition key switch OFF, disconnect Z3, use SST 09232-13130-71 to short circuit Z3-2 and Z3-3, ignition key switch ON, engine stopped 71-1 displayed to inspection 2 71-2 displayed Tire angle sensor defect Section 19 SAS/OPS controller 30 (5T) 2 4 3 34 (T) 8 3 2 REC TAB TAB REC 5 (E2) 11 1 1 Tire angle sensor 34 (T) 8 EC B B C 3 2 5 (E2) 11 R TA TA RE 1 1 Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of Z3, AO1, ZO1 and A21, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (engine stopped) and check whether or not there is an error. No error Error Inspection 1:

Tire angle sensor individual inspection 71-1 is displayed Inspection 2: Harness continuity and short circuit inspection OK Inspection 3: Harness continuity and short circuit inspection NG