19-98 19-98 Electrical System Troubleshooting Inspection 2: Inspect for continuity and short circuiting of the harness. Ignition key switch OFF, disconnect A21 (With the SST used in inspection 1 still connected) Standard: Inspection 3: Inspect for continuity and short circuiting of the harness. In the same state as for inspection 2 Standard: Error code 71-2 Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of Z3, AO1, ZO1 and A21, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (engine stopped) and check whether or not there is an error.
No error Connector contact defect Error 71-1 is displayed Inspection 1: Tire angle sensor individual inspection 71-2 is displayed OK Inspection 2: Harness continuity and short circuit inspection SAS/OPS controller defect NG No continuity Inspection 3: Tire angle sensor individual inspection Main harness defect Continuity Tire angle sensor defect Inspection 1: Carry out tire angle sensor individual inspection. Ignition key switch OFF, disconnect Z3, ignition key switch ON, engine stopped 71-1 displayed to inspection 3 71-2 displayed to inspection 2 Section 19 A21-30 ~ A21-34 Continuity A21-34 ~ A21-5 No continuity A21-30 ~ Frame No continuity A21-34 ~ Frame No continuity