Toyota — Service Manual Change History

19-145 Electrical System Troubleshooting Error codes H4-1, H4-2, H4-3, H4-4 Disconnect the battery negative terminal, after inspecting and correcting disconnect and water entry of A21, A23, AO3, XO2, YX1 and Y3, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON, and check whether or not there is an error. No error Connector contact defect Error Turn the ignition key switch OFF, disconnect the battery negative terminal, replace the attachment 1 lever potentiometer with the attachment 2 lever potentiometer, and check if there is any change in the error. Inspection 1:

Attachment 2 lever potentiometer inspection H3-4 NG Installation defect OK H4-* Attachment 2 lever potentiometer abnormality H3-1·H3-2·H3-3 Inspection 2: Harness continuity and short circuit inspection NG Harness defect OK Replace fuse NG Fuse inspection OK SAS/OPS/mini lever Note: If the lever has been removed, be sure to perform matching after the lever is reinstalled. Inspection 1: Carry out attachment 2 lever potentiometer inspection.

Ignition key switch OFF, return the attachment 2 lever potentiometer and tilt lever potentiometer to their original positions Check attachment 2 lever potentiometer installation (refer to section 18), ignition key switch ON, match attachment 2 lever potentiometer Section 19