Toyota — Service Manual Change History

19-163 Electrical System Troubleshooting Defect Causes When There is No SAS/OPS Error Display Note: If an error code or wrench lamp is flashing, repair it first. Section 19 Corrective action Harness check or replace switch If not close to 0%, installation check or replace sensor. Replace Harness check or replace switch Change Replace Checking method ON/OFF check with analyzer Accelerator pedal position check: Check the opening degree of the accelerator pedal when not operated. – ON/OFF check with analyzer Check settings with option set and tuning – Malfunction area · mode Brake switch unit: Open fault (Stuck in depressed state, or internal damage) Brake switch line:

Disconnection fault (Harness, connector, fuse) Accelerator sensor unit: Internal damage Accelerator sensor installation: Link, installation part destroyed, damaged SAS/OPS controller: Controller defect Lift raise switch unit: Open fault (Switch mounted incorrectly, internal damage, stuck) Lift raise switch line: Disconnection fault (Harness, connector) Switch ground line: Disconnection fault (Harness, connector) Display setting: Lift idle up disabled, Idle up speed tuning value low SAS/OPS controller: Controller defect Phenomenon on vehicle For vehicles with travel and load handling control: Engine is always slow to rev up.

(Even with the direction lever left in F or R position and the brake applied, the engine is still slow to rev up) For vehicles with travel and load handling control: Even if the lift is raised, the idle speed does not rise. Control type Travel and load handling control