Toyota — Service Manual Change History

19-169 Electrical System Troubleshooting Section 19 Corrective action If there is no change, perform an installation check, harness check, or replace the switch (lever). If there is no change, perform an installation check, harness check, or replace the switch (lever). Follow the procedure for matching, and rematch (cylinder bore, number of cylinders, 0 point correction) In cases where precision is required, adjust on the load indicator matching LOAD CALIBRATION screen. If there is no change during the voltage check, perform a harness check or replace the sensor.

Checking method ON/OFF check with analyzer ON/OFF check with analyzer Carry out rematching and check operation Load sensor voltage check: Mount a load, ground the forks and check the change in voltage * At high lifting height, correct load cannot be calculated and the display flashes. Malfunction area · mode Load indicator switch unit: Open fault (Internal damage) Load indicator switch detection mechanism (Mini lever, joystick): Detection part gap adjustment defect Load indicator switch line (Power supply, signal, ground): Open fault (Power supply, harness, connector) Load indicator switch unit: Short fault (Internal damage) Load indicator switch detection mechanism (Mini lever, joystick):

Detection part gap adjustment defect Load indicator switch line (Signal): Short fault (Harness, connector) Display setting: Cylinder bore, number of cylinders, 0 point correction, calibration Phenomenon on vehicle Vehicles with multifunction display DX: When the load indicator switch is pressed, the load is not displayed. Vehicles with multifunction display DX: When the vehicle is stopped, the display continually shows load indicator. Vehicles with multifunction display DX: The correct load is not displayed. Control type Display function