19-170 Electrical System Troubleshooting Section 19 Corrective action Harness check or replace sensor, or replace SAS/OPS controller Harness check or replace sensor, or replace SAS/OPS controller If the TEMPGAUGE is set to NO on the option set screen, change it to YES, and if MTC on the analyzer I/O OTHERS screen is set to 1, perform a harness check or replace the SAS/ OPS controller. Checking method Start the engine and after leaving the vehicle running for a while, check the indicator. Stop the engine and after leaving the vehicle stopped for a while, check the indicatior.
Check that the TEMPGAUGE on the option set screen is set to YES, and that the MTC on the analyzer I/O OTHERS screen is set to 0. Malfunction area · mode Torque converter oil temperature sensor unit: Open fault (Internal damage) Torque converter oil temperature sensor line (Signal, ground): Disconnection fault (Harness, connector) +B short fault (Harness, connector) SAS/OPS controller: Controller defect Torque converter oil temperature sensor unit: Short fault (Internal damage) Torque converter oil temperature sensor line (Signal): Ground short fault (Harness, connector) SAS/OPS controller: Controller defect There is no display on MT vehicles. Display setting:
Torque converter oil temperature emergency setting enabled SAS/OPS controller: Controller defect (MTC line short) Phenomenon on vehicle Vehicles with multifunction display DX: Torque converter oil temperature indicator stays at level 1. Vehicles with multifunction display DX: Torque converter oil temperature indicator continually displays overheat warning indication. Vehicles with multifunction display DX: Torque converter oil temperature indicator does not display. Control type Display function