Toyota — Service Manual Change History

19-171 Electrical System Troubleshooting Section 19 Corrective action Adjust or replace Replace If there is no change, perform an installation check or replace the sensor. Harness check or replace switch Installation check or replace sensor If there is no change, perform an installation check or replace the sensor. Replace Checking method – Check the locked status with an active test. Load sensor voltage check: Peform lift relief and check the change in voltage. ON/OFF check with analyzer Yaw rate sensor voltage check: Check that the voltage is approximately 2.5 V when the vehicle is stopped. Check sensor voltage and vehicle speed with the analyzer – Malfunction area · mode Tire unit:

Burst, tire pressure adjustment defect Lock cylinder unit: Leak, cannot lock (Internal damage) Lock cylinder locked status: Installation part damaged or destroyed Load sensor unit: Sensor defect Load sensor line (Power supply, signal, ground): Disconnection fault (Harness, connector) Short or leak fault (Harness, connector) Lifting height switch unit: Disconnection fault (Internal damage, stuck) Yaw rate sensor unit: Reduced sensitivity, voltage stuck (Internal damage) Yaw rate sensor line (Signal): Leak (Harness, connector) Vehicle speed sensor unit: Cannot detect low speeds (Internal damage) Vehicle speed sensor line (SPD+ side, SPD- side):

Leak fault (Harness, connector) SAS/OPS controller: Controller defect Phenomenon on vehicle Feels unstable when traveling. (Traveling lock has become difficult or no longer possible) Control type Swing lock