Toyota — Service Manual Change History

19-172 Electrical System Troubleshooting Section 19 Corrective action Replace Harness check or replace solenoid If there is no change, perform an installation check or replace the sensor. Harness check or replace switch Installation check or replace sensor Replace Checking method Check the locked status with an active test. Check the locked status with an active test. Load sensor voltage check: Peform lift relief and check that the voltage rises. ON/OFF check with analyzer Yaw rate sensor voltage check: Check that the voltage is approximately 2.5 V when the vehicle is stopped. – Malfunction area · mode Lock cylinder unit: Lock stuck (internal damage) Swing lock solenoid line (SWN+, SWN-):

Disconnection fault (Harness, connector) Solenoid ground line (E01, E02): Disconnection fault (Harness, connector) Load sensor unit: Sensor defect Load sensor line (Power supply, signal, ground): Disconnection fault (Harness, connector) Short or leak fault (Harness, connector) Lifting height switch unit (2200H): Disconnection fault (internal damage, stuck) Lifting height switch unit (4000H): Disconnection fault (internal damage, stuck) Yaw rate sensor unit: Reduced sensitivity, voltage stuck (Internal damage) SAS/OPS controller: Controller defect Phenomenon on vehicle Swing lock continually activates while traveling and material handling operations, or swing lock activates frequently.

Control type Swing lock