Toyota — Service Manual Change History

19-177 Electrical System Troubleshooting Section 19 Corrective action If there is no change, perform an installation check or replace the sensor. Follow matching procedure to rematch. Harness check or replace switch Change Replace – Checking method Tilt angle sensor voltage check: Tilt to forward and backward tilt positions and check the voltage change. – ON/OFF check with analyzer Check the option set content – – Malfunction area · mode Tilt angle sensor unit: Sensor defect Tilt angle sensor installation: Link, installation part destroyed, damaged Horizontal matching value for tilt angle sensor: Does not match actual status (rematch) Automatic fork leveling switch unit:

Open fault (internal damage) Automatic fork leveling switch detection mechanism (mini lever, joystick): Detection part gap adjustment defect Automatic fork leveling switch line (Power supply, signal, ground): Disconnection fault (Harness, connector) Display setting (mini lever, joy stick): • 3/4-way change over specification set to 2/3-way change over setting • Backward tilt automatic fork leveling is deactivated SAS/OPS controller: Controller defect Refer to forward tilt automatic fork leveling does not stop (stops at the position where the automatic leveling switch is pressed). Phenomenon on vehicle Mini lever, joystick vehicles: Backward tilt automatic fork leveling does not stop.

(Continues to tilt to backward most tilt position without stopping at the level position) Mini lever, joystick vehicles: Backward tilt automatic fork leveling does not stop. (Stops at a position slightly off the level position) Control type Mini lever function