Toyota — Service Manual Change History

19-178 Electrical System Troubleshooting Section 19 Corrective action If there is no change, perform an installation check or replace the sensor. Follow matching procedure to rematch. Replace Harness check or replace switch Harness check or replace relay Replace Checking method Tilt angle sensor voltage check: Tilt to forward and backward tilt positions and check the voltage change. – – ON/OFF check with analyzer Check the changeover status with an active test. – Malfunction area · mode Tilt angle sensor unit: Sensor defect Tilt angle sensor installation: Link, installation part destroyed, damaged Horizontal matching value for tilt angle sensor:

Does not match actual status (rematch) SAS/OPS controller: Controller defect Lever change over switch unit: Open fault (internal damage) Lever change over switch detection mechanism (mini lever): Detection part gap adjustment defect Lever change over switch line (Power supply, signal, ground): Disconnection fault (Harness, connector) Lever change over relay 1 or 2 unit: Stuck, welding fault (internal damage) Lever change over relay 1 or 2 primary side line: Disconnection fault (wire, connector) SAS/OPS/mini lever controller: Controller defect Phenomenon on vehicle Mini lever, joystick vehicles: Backward tilt automatic fork leveling does not stop.

(Stops at the position where the automatic fork leveling switch is pressed) Mini lever 3/4-way (2/3-way) change over specification: 3-way (2-way) operation even when the lever change over switch is pressed. (Does not change over) Control type Mini lever function