Toyota — Service Manual Change History

19-181 Electrical System Troubleshooting Section 19 Corrective action If there is no change, perform an installation check or replace the sensor. Follow matching procedure to rematch. Harness check or replace sensor Replace Replace If there is no change, perform an installation check or replace the sensor. Replace Checking method Tire angle sensor voltage check: Operate the steering and check the change in voltage. – Check sensor voltage with the analyzer. Using an active test, turn the knob compensation SOL ON and OFF and operate the steering at the tire end. SOL ON: Check that the steering wheel can be turned freely. SOL OFF:

Check that the steering wheel cannot be turned freely (steering is heavy). – Check sensor voltage and vehicle speed with the analyzer. – Malfunction area · mode Tire angle sensor unit: Sensor defect Tire angle sensor installation: Looseness of the attachment part, damage, bearing housing damage Tire angle sensor matching value: Does not match actual status (rematch) Steering angle sensor unit: Sensor defect Steering angle sensor installation: Cam or steering wheel defect Knob compensation valve unit: Leak, stuck, (internal damage) PS cylinder system link defect: Eccentric pin, kingpin defect Vehicle speed sensor unit:

Cannot detect low speed (internal damage) Vehicle speed sensor installation: High speed not detected correctly (sensor tip has metallic particle adhered) Vehicle speed sensor line (SPD+ side, SPD- side): Leak fault (Harness, connector) SAS/OPS controller: Controller defect Phenomenon on vehicle Knob position is out of alignment. (Knob position is not constant when traveling straight ahead) Control type Knob compensation control