19-182 Electrical System Troubleshooting Section 19 Corrective action Check for blown fuse Harness check Keep the engine at high speed for a while. Follow matching procedure to rematch. Replace Replace Harness check Replace Harness check or replace connector Replace Checking method – – Check battery voltage with the analyzer. – – – – – – – Malfunction area · mode Fuse: ECU+B fuse blown ECU-IG fuse blown Meter communication line: Ground short (Harness, connector) Disconnection fault (Harness, connector) SAS/OPS IG line, +B line, ground system: Disconnection fault (Harness, connector) Battery unit:
Low voltage, intake heater, large current auxiliary equipment operation SAS/OPS controller setting: Not matched Meter unit: Meter defect SAS/OPS controller: Controller defect Meter power supply line: Disconnection fault (Harness, connector) Meter unit: Meter defect Hour meter start fuse: Not connected Hour meter start signal line: Disconnection fault (Harness, connector) Meter unit: Meter defect Phenomenon on vehicle Wrench lamp is lit continually. The wrench lamp does not light even when the ignition key switch is turned ON. Hour meter is not displayed. Control type Meter