Toyota — Service Manual Change History

19-48 19-48 Electrical System Troubleshooting Inspection 1: Carry out switch input signal inspection. Ignition key switch ON Switch input signal (I/O monitor: G/LP, SEL1-4) Standard: Inspection 2: Carry out fuel changeover switch individual inspection. (Carry out only for convertible vehicles, and only when the G/LP input in inspection 1 is outside the standard value) G88 Ignition key switch OFF, disconnect G88, connect G28 and G27 Standard: (Switch side) Inspection 3: Inspect for continuity and short circuiting of the harness.

(Begin with the place that was outside the standard value in inspection 1) Ignition key switch OFF, disconnect G28, G27 and G88 Section 19 Vehicle specification Fuel changeover switch G/LP SEL Gasoline specification – 10 1100 LPG exclusive – 01 0101 LPG/Gasoline convertible Gasoline selection 10 0110 LPG selection 01 Neutral 00 Gasoline/CNG convertible Gasoline selection 10 0101 CNG selection 01 Neutral 00 Fuel changeover switch Gasoline LPG/CNG Neutral G88-2 ~ G88-3 Continuity No continuity No continuity G88-2 ~ G88-1 No continuity Continuity No continuity Vehicle specification Harness SEL1 SEL2 SEL3 SEL4 Gasoline specification Short circuit to ESEL Short circuit to ESEL – – LPG exclusive Short circuit to ESEL Short circuit to ESEL Short circuit to ESEL – LPG/Gasoline convertible – Short circuit to ESEL Short circuit to ESEL – Gasoline/CNG convertible – Short circuit to ESEL – Short circuit to ESEL