Toyota — Service Manual Change History

19-61 Electrical System Troubleshooting z Error codes 18-1, 18-2 (4Y engine: Cam angle sensor abnormality) Related portion G25 Probable cause c Distributor (cam angle sensor) defect d Starter defect e Defect in the part connecting the starter and engine f Harness defect g Engine controller defect Caution: If the engine does not crank, troubleshoot "Does not crank (see 19-156)" first.

Error codes 18-1, 18-2 Connector contact defect Distributor (cam angle sensor) defect Starter defect Defect in the part connecting the starter and engine Harness defect Engine controller defect Section 19 3 (IG2) 5 (IG1) Igniter G21 G27 2 (IG-) Engine 1 (IG+) controller G19 Distributor 31 (NE+) 1 (NE) 30 (NE-) 2 (NE-) Igniter Engine controller Distributor Disconnect the battery negative terminal (for more than 10 seconds), after inspecting and correcting disconnection and water entry of G19, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (start the engine) and check whether or not there is an error. No error Error Inspection 1:

Distributor individual inspection OK Inspection 2: Timing rotor operation inspection OK Inspection 3: Harness continuity and short circuit inspection OK