19-65 Electrical System Troubleshooting z Error codes 18-1, 18-2 (1DZ-II, 2Z engines: NE sensor abnormality) Related portion G39 G31 Probable cause c Connector contact defect d Engine speed sensor defect e Harness defect f ASC controller defect Caution: In the event that the engine stops while traveling, when the ignition key switch is turned from OFF to ON, an 18-2 error may be detected, however this is not a fault. Stop the vehicle, turn the ignition key switch OFF and restart the engine. Error codes 18-1, 18-2 Connector contact defect Harness defect Engine speed sensor defect ASC controller defect Inspection 1: Inspect for continuity and short circuiting of the harness.
Ignition key switch OFF, disconnect G31 and G39 Standard: Section 19 ASC controller 9 (NE+) 2 (NE) 22 (NE-) 1 (NE-) Engine speed sensor (NE sensor) Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of G31 and G39, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON and check whether or not there is an error. No error Error Inspection 1: Harness continuity and short circuit inspection OK Inspection 2: Engine speed sensor individual inspection OK G39-9 ~ G31-2 Continuity G39-22 ~ G31-1 Continuity G39-9 ~ G39-22 No continuity