19-73 Electrical System Troubleshooting z Error code 54-1 (Swing lock solenoid abnormality) Related portion A20 AO1 ZO1 Z1 Swing lock solenoid SAS/OPS controller 9 (E02) Probable cause c Connector contact defect d Harness defect e Swing lock solenoid defect f SAS/OPS controller defect Error code 54-1 Connector contact defect Swing lock solenoid defect Harness defect SAS/OPS controller defect *: Make sure that no error is displayed when driving in a circle or during repeated left and right turns. Inspection 1: Carry out swing lock solenoid individual inspection. Ignition key switch OFF, disconnect Z1 2 1 Standard:
(Solenoid side) Z1 Section 19 C C 2 (SWN-) 13 E TAB TAB E 2 2 R R Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of A20, AO1, ZO1 and Z1, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (start the engine) and check whether or not there is an error. No error Error Inspection 1: Swing lock solenoid individual inspection OK Inspection 2: Harness continuity and short circuit inspection OK Z1-1 ~ Z1-2 Approx. 6 Ω (20°C)