19-72 19-72 Electrical System Troubleshooting Inspection 2: Inspect for continuity and short circuiting of the harness. Ignition key switch OFF, disconnect O1 and A21 Standard: Error codes 52-2, 52-3 Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of O1, AO1 and A21, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (engine stopped) and check whether or not there is an error.
No error Connector contact defect Error Turn the ignition key switch OFF, disconnect the battery negative terminal, disconnect O1, connect the battery negative terminal, turn the ignition key switch ON (engine stopped), check whether the error changes. Inspection 2: Yaw-rate sensor inspection 52-1 Yaw-rate sensor defect Continuity No continuity 52-2 or 52-3 Harness defect Inspection 1: Harness continuity and short circuit inspection NG OK SAS/OPS controller defect Inspection 1: Inspect for continuity and short circuiting of the harness. Ignition key switch OFF, disconnect O1 and A21 Standard: Inspection 2:
Yaw-rate sensor inspection Ignition key switch OFF, disconnect A21 and O1, use SST 09232-13130-71 to short circuit O1-2 to O1-3 (main harness side) Standard: Section 19 A21-25 ~ O1-3 Continuity A21-26 ~ O1-2 Continuity A21-24 ~ O1-1 Continuity A21-24 ~ Frame No continuity A21-25 ~ Frame No continuity A21-26 ~ Frame No continuity A21-25 ~ O1-3 Continuity A21-26 ~ O1-2 Continuity A21-24 ~ O1-1 Continuity A21-24 ~ Frame No continuity A21-25 ~ Frame No continuity A21-26 ~ Frame No continuity A21-25 ~ A21-26 Continuity A21-25 ~ Frame No continuity A21-26 ~ Frame No continuity