Toyota — Service Manual Change History

19-71 Electrical System Troubleshooting z Error codes 52-1, 52-2, 52-3 (Yaw rate sensor abnormality) Related portion A21 AO1 O1 Probable cause c Connector contact defect d Yaw rate sensor harness defect e Yaw rate sensor defect f SAS/OPS controller defect Error code 52-1 Connector contact defect Yaw rate sensor defect Harness defect SAS/OPS controller defect Inspection 1:

Ignition key switch OFF, disconnect O1, use SST 09232-13130-71 to short circuit O1-1 and O1-3, ignition key switch ON, engine stopped 52-1 displayed to inspection 2 52-2 displayed Yaw rate sensor defect Section 19 SAS/OPS controller 24 (YRS+) 4 1 25 (YRS) 6 3 REC TAB 26 (YRS-) 5 2 Yaw-rate sensor 25 (YRS) 6 EC B 3 26 (YRS-) 5 R TA 2 Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of O1, AO1 and A21, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (engine stopped) and check whether or not there is an error. No error Error Inspection 1: Yaw rate sensor inspection 52-1 is displayed Inspection 2:

Harness continuity and short circuit inspection OK