19-76 19-76 Electrical System Troubleshooting Inspection 2: Inspect for continuity and short circuiting of the harness. Ignition key switch OFF, disconnect A21 (with the SST used in inspection 1 still connected) Standard: Inspection 3: Inspect for continuity and short circuiting of the harness. In the same state as for inspection 2 Standard: Error code 61-2 Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of A18 and A21, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (engine stopped) and check whether or not there is an error.
No error Connector contact defect Error Disconnect A18, ignition key switch ON (engine stopped), inspect the diplayed error code. 61-1 61-2 No continuity Inspection 1: Harness continuity and short circuit inspection SAS/OPS controller defect Continuity No continuity Main harness defect No continuity Inspection 2: Load sensor individual inspection Main harness defect Continuity Continuity · Sub harness defect · Load sensor defect Inspection 1: Inspect for continuity and short circuiting of the harness. Ignition key switch OFF, disconnect A21 Standard:
Section 19 A21-19 ~ A21-27 Continuity A21-27 ~ A21-5 No continuity A21-19 ~ Frame No continuity A21-27 ~ Frame No continuity A21-19 ~ A21-27 No continuity A21-19 ~ Frame No continuity A21-27 ~ Frame No continuity