19-79 Electrical System Troubleshooting Inspection 2: Inspect for continuity and short circuiting of the harness. Ignition key switch OFF, disconnect A21 (with the SST used in inspection 1 still connected) Standard: Inspection 3: Inspect for continuity and short circuiting of the harness. In the same state as for inspection 2 Standard: Error code 62-2 Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of A21 and A42, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (engine stopped) and check whether or not there is an error. No error Connector contact defect Error 62-1 is displayed Inspection 1:
Tilt angle sensor individual inspection 62-2 is displayed No continuity Inspection 2: Harness continuity and short circuit inspection SAS/OPS controller defect Continuity No continuity Inspection 3: Tilt angle sensor individual inspection Main harness defect Continuity Tilt angle sensor defect Inspection 1: Carry out tilt angle sensor individual inspection. Ignition key switch OFF, disconnect A42, ignition key switch ON, engine stopped 62-1 displayed to inspection 3 62-2 displayed to inspection 2 Inspection 2: Inspect for continuity and short circuiting of the harness. Ignition key switch OFF, disconnect A21 Standard:
Section 19 A21-28 ~ A21-32 Continuity A21-32 ~ A21-5 No continuity A21-28 ~ Frame No continuity A21-32 ~ Frame No continuity A21-28 ~ A21-32 No continuity