Toyota — Service Manual Change History

19-82 19-82 Electrical System Troubleshooting Error codes 63-1, 63-2, 63-3 Harness defect *: Make sure there is no error displayed after turning the ignition key switch ON, and moving the tilt lever forward and backward. Also, make sure that no error is displayed when the tilt lever is left standing in neutral position for 2 minutes. Inspection 1: Check the condition of the switch. Ignition key switch ON, engine stopped Tilt switch (I/O monitor: MF·MR) Standard:

Section 19 Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of A13 and A20, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON and check whether or not there is an error.* Error Inspection 1: Check the condition of the switch ANL.: I/O M.HANDLING 1/6 Inspection 2: Individual continuity inspection of the tilt lever switch(es) that was abnormal in inspection 1 (while still installed on the vehicle). NG Inspection 3: Individual continuity inspection of the tilt lever switch (removed from the vehicle). OK Inspection 4:

Harness continuity and short circuit inspection NG Lever in neutral position Lever in forward tilt position Lever in backward tilt position MF (Forward tilt switch) 0 1 0 MR (Backward tilt switch) 0 0 1