19-90 19-90 Electrical System Troubleshooting Error code 67-1 Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of A20, A61 and b1, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (engine stopped) and check whether or not there is an error.* Error None Connector contact defect *: Raise the lift lever from the fully lowered position until an error is detected. Error Inspection 1: Lifting height switch input value inspection ANL.: I/O M.HANDLING 2/6 Except MH000 Inspection 2: Harness continuity and short circuit inspection ANL.:
I/O M.HANDLING 2/6 Lifting height switch defect MH:000 MH:000 Except MH:000 Inspection 3: Harness continuity and short circuit inspection OK SAS/OPS controller defect NG Main harness defect Inspection 4: Lifting height switch individual inspection Lifting height switch defect NG OK Inspection 5: Harness continuity and short circuit inspection OK SAS/OPS controller defect NG Main harness defect Section 19