Toyota — Service Manual Change History

19-91 Electrical System Troubleshooting Inspection 1: Check the condition of the switch. Maintain the error status and check the display. Lifting height switch (I/O monitor: MH) MH: 000 displayed to checking the mast height at the time of error detection MH: Except 000 to inspection 2 Inspection 2: Inspect for continuity and short circuiting of the harness. Put the lift in fully lowered state, ignition key switch OFF, disconnect A20 and b1, ignition key switch ON, stop the engine, check the display MH: 000 displayed sub harness defect or lifting height switch defect MH: Except 000 to inspection 3 Inspection 3: Inspect for continuity and short circuiting of the harness.

Put the lift in fully lowered state, ignition key switch OFF, disconnect A20 and b1 Standard: Inspection 4: Carry out lifting height switch individual inspection. 1 2 3 Maintain the error status, ignition key switch OFF, disconnect b1 b1 Standard: (Switch side) Inspection 5: Inspect for continuity and short circuiting of the harness. Put the lift in fully lowered state, ignition key switch OFF, disconnect A20 adn b1, use SST 09236-13900-71 to short circuit the terminals Standard:

Section 19 A20-1 ~ A20-31 No continuity A20-1 ~ A20-32 No continuity A20-1 ~ A20-33 No continuity A20-31 ~ A20-32 No continuity A20-32 ~ A20-33 No continuity A20-33 ~ A20-31 No continuity A20-31 ~ Frame No continuity A20-32 ~ Frame No continuity A20-33 ~ Frame No continuity b1-1 ~ b1-2 No continuity b1-1 ~ b1-3 Continuity Inspection terminal Short circuit terminals Continuity A20-1 ~ A20-31 b1-1 ~ b1-2 Continuity A20-1 ~ A20-32 b1-1 ~ b1-3 Continuity