Toyota — Service Manual Change History

19-93 Electrical System Troubleshooting Error codes 68-1, 68-2, 68-3 Harness defect *: Make sure there is no error displayed after turning the ignition key switch ON, and moving the lift lever upward and downward. Also, make sure that no error is displayed when the lift lever is left standing in neutral position for 2 minutes. Section 19 Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of A14 and A20, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (engine stopped) and check whether or not there is an error.* Error Inspection 1: Lift switch condition check ANL.: I/O M.HANDLING 1/6 Inspection 2:

Individual continuity inspection of the lift lever switch(es) that was abnormal in inspection 1 (while still installed on the vehicle). NG Inspection 3: Individual continuity inspection of the lift lever switch (removed from the vehicle). OK Inspection 4: Harness continuity and short circuit inspection NG