19-95 Electrical System Troubleshooting z Error code 69-1 (Backward tilt lock solenoid abnormality) Related portion A20 A56 10 (BSO+) 1 Backward tilt lock solenoid 2 SAS/OPS controller 8 (E01) 9 (E02) Probable cause c Connector contact defect d Harness defect e Backward tilt lock solenoid defect f SAS/OPS controller defect Error code 69-1 Connector contact defect Harness defect Solenoid defect SAS/OPS controller defect *: Make sure that no error is displayed when the material handling lever is operated to tilt backward. Inspection 1: Carry out harness continuity and short circuit inspection. Ignition key switch OFF, disconnect A20 and A56 Standard:
Section 19 Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of A20 and A56, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (engine stopped) and check whether or not there is an error.* No error Error Inspection 1: Harness continuity and short circuit inspection OK Inspection 2: Backward tilt lock solenoid individual inspection OK A20-10 ~ A56-1 Continuity A56-2 ~ Frame Continuity A20-9 ~ Frame Continuity A20-8 ~ Frame Continuity A20-10 ~ Frame No continuity