OM4035.2 02/03 Maintenance - Section 4 Automatic Lube System Page 4- 21 INJECTORS (SL-1 Series “H”) Injector Specifications • Each lube injector services only one grease point. In case of pump malfunction, each injector is equipped with a covered grease fitting to allow the use of exter- nal lubricating equipment. • Injector output is adjustable: Maximum output = 0.08 in 3 (1.31 cc). Minimum output = 0.008 in 3 (0.13 cc). • Operating Pressure: Minimum - 1850 psi (12 755 kPa) Maximum - 3500 psi (24 133 kPa) Recommended - 2500 psi (17 238 kPa) Maximum Vent Pressure - (Recharge) 600 psi (4 137 kPa) Injector Adjustment to 0.08 in 3 (0.13 cc to 1.31 cc) of lubricant per injection cycle.
The injector piston travel distance determines the amount of lubricant supplied. This travel is in turn con- trolled by an adjusting screw in the top of the injector housing. The injectors may be adjusted to supply from 0.008 in 3 Turn the adjusting screw (1, Figure 3-8) counterclock- wise to increase lubricant amount delivered and clock- wise to decrease the lubricant amount. When the injector is not pressurized, maximum injector delivery volume is attained by turning the adjusting screw (1) fully counterclockwise until the indicating pin (8) just touches the adjusting screw. At the maximum delivery point, about 0.38 inch (9.7 mm) adjusting screw threads should be showing.
Decrease the delivered lubricant amount by turning the adjusting screw clock- wise to limit injector piston travel. If only half the lubricant is needed, turn the adjusting screw to the point where about 0.19 inch (4.8 mm) threads are showing. The injector will be set at minimum delivery point with about 0.009 inch (0.22 mm) thread showing. NOTE: The above information concerns adjustment of injector delivery volume. The timer adjustment should also be changed, if overall lubricant delivery is too little or too much. Injector output should NOT be adjusted to less than one-fourth capacity . FIGURE 3-8. TYPE SL-1 INJECTOR 1. Adjusting Screw 12. Plunger 2. Locknut 13. Viton Packing 3.
Piston Stop Plug 14. Inlet Disc 4. Gasket 15. Viton Packing 5. Washer 16. Washer 6. Viton O-Ring 17. Gasket 7. Injector Body Assy. 18. Adapter Bolt 8. Piston Assembly 19. Adapter 9. Fitting Assembly 20. Viton Packing 10. Plunger Spring 11. Spring Seat NOTE: The Piston Assembly (8) has a visible indicato pin at the top of the assembly to verify the injector ope ation. r r-