Komatsu — FILTER AND RESERVOIR

Maintenance - Section 4 OM4035.2 02/03 Page 4- 20 Automatic Lube System FILTER AND RESERVOIR Filter Assembly A filter assembly (2, Figure 3-6) is mounted on the right upright (1) and filters the grease when the grease supply is refilled through the “quick fill” fittings. The filter assembly element (5, Figure 3-7) should be replaced if the bypass indicator (2) shows excessive element restriction. Grease is pumped into the filter through a hose (4) routed from the Service Center and then flows out the filter through a hose (3) to the reservoir (5). A vent hose (7) purges air from the reservoir as it is being filled and prevents a vacuum as grease is pumped out.

A cap (6) allows the reservoir to be drained if desired and a plate secured on the end of the reservoir (frame torque tube) can be removed if the reservoir requires cleaning. FIGURE 3-7. FILTER ASSEMBLY 1. Housing 2. Bypass Indicator 3. O-Ring 4. Backup Ring 5. Element 6. Spring 7. Bowl 8. O-Ring 9. Plug FIGURE 3-6. FILTER AND RESERVOIR 1. R.H. Upright 2. Filter Assembly 3. Filter Outlet Hose 4. Filter Inlet Hose 5. Grease Reservoir 6. Cap 7. Vent Hose 8. Pump Access Door