Komatsu — CENTER CONSOLE

Operation - Section 3 OM3035.2 02/03 Page 3-20 Operator Cab and Controls OVERRIDE SWITCH This push-but- ton switch (9, Figure 3-4) is spring-loaded to the "OFF" posi- tion. When pushed in and held, this switch may be used for sev- eral functions. RETARD SPEED CONTROL (RSC) ADJUST DIAL The RSC Adjust Dial (12, Figure 3-4) allows the operator to vary the downhill truck speed that the Retard Speed Control system will maintain when descending a grade. When the dial is rotated counterclockwise toward this symbol, the truck will descend a grade at lower speeds. 1.

The override switch permits the operator to move the truck forward when the Selector Switch is in Forward, the dump body is raised, and the brakes are released. ! Use of the override switch for this purpose is intended for emergency situations only! When the dial is rotated clockwise toward this symbol, the truck speed will increase. Throttle pedal position will override RSC setting. If operator depresses throttle pedal to increase truck speed, Dynamic Retarding will not come on unless truck overspeed setting is reached or foot operated retard pedal is used.

When throttle pedal is released and RSC switch is "On", Dynamic Retarding will come on at, or above, the RSC dialed speed and will adjust truck speed to, and maintain, the dialed speed. 2. If the operator stops the truck on an uphill incline, the override switch can be used to set up forward propulsion while the brakes are applied. As soon as forward propulsion is felt, release the brakes and as the truck begins to move forward, release the override switch. 3. The push button deactivates the retard pedal function when speed of truck is below 3 mph (4.8 kph).

To adjust RSC control, pull switch (11) "On" and start with dial (12) rotated toward fastest speed while driv- ing truck at desired maximum speed. Relax throttle pedal to let truck coast and turn RSC Adjusting Dial slowly counterclockwise until Dynamic Retarding is activated. Dynamic Retarding will now be activated automatically anytime the "set" speed is reached, the RSC switch is "On", and throttle pedal is released. 4. The override switch is also used to reset an electric system fault when indicated by the red warning light (Refer to "Instrument Panel And Indicator Lights", Overhead Warning / Status panel). With RSC switch "On" and dial adjusted, the system aintain when se nd rd e.

SC setting. If crease truck 10, FIGURE 3-4 - BLAN This position is not used 730E. In some other truck mod tion is used for an Engine RETARD SPEED CONT "OFF/ON" SWITCH The Retard Speed C Switch (11, Figure 3-4) the system "OFF" or Push the knob "IN" to "OFF" and pull the knob to turn the system "ON". will function as follo K the "set" speed and for the Retarding will apply the amount of retard to keep the selec decreases, the reta els, this posi- the selected spee Idle Switch. decrease to appro "set" speed, Dynam ically. If truck spee operator can turn th depress the foot op ROL (RSC) ontrol “IN” “OFF” turns "ON". turn "OUT" “OUT” “ON” ws: A thrott . As tr ing ef ted s “OFF” trol rns N".

urn “IN” “ OFF” UT" “OUT ” “ ON” “ or the s, this posi- the a to k is posi - Switch.