OM3035.2 02/03 Operation - Section 3 Operator Cab and Controls Page 3-21 The RSC Adjust Dial (12, Figure 3-4) Continued If the operator depresses the foot operated retard pedal and the retard effort called for is greater than that from the automatic system, the foot pedal retard will override RSC. PAYLOAD METER The Payload Meter (1, Figure 3-5) and Download Connector (2) are used to provide management with operational data such as tonnage hauled and cycle times. STATEX III DOWNLOAD PORT Refer to Section 6, Optional Equipment, for a more complete description of the payload meter and its functions. This connector (13, Figure 3-4) is for use by qualified personnel to access G.E.
STATEX III electric propul- sion diagnostic information and data. Payload Meter Download Connector KOMATSU ENGINE CENSE CONNECTOR This 3-pin connector (14, Figure 3-5) is for use by qualified personnel to access engine diagnostic infor- mation for the CENSE system. Refer to engine man- ufacturer’s service publications for troubleshooting information. This connector (2, Figure 3-5) is used with a special cable to allow the Payload Meter (1) to communicate with a Portable Computer. MODULAR MINING PORT This connector (15, Figure 3-5) location is used if the optional Modular Mining System is installed on the truck.
PASSENGER SEAT The Passenger Seat (16, Figure 3-4) is mounted on top of the right hand portion of the Center Console structure. The area beneath the passenger seat provides a cabinet for various 24 VDC electrical components. Consult the Service Manual for service involving any of these components. Centry™ Fuel Control DIAGNOSTICS DOWNLOAD PORT This connector (17, Figure 3-4) is for use by qualified personnel to access the Engine Centry™ Fuel Con- trol system diagnostic information. FIGURE 3-5. PAYLOAD METER 1. Payload Meter 2. Download Connector ENGINE DIAGNOSTICS PORT This connector (18, Figure 3-4) is used by qualified personnel to access engine diagnostic information.
DATA STORAGE BUTTON This button (19, Figure 3-5) is for use by qualified maintenance personnel to record in memory a “snap- shot” of the Statex III drive system.